![]() See xscreensaver(1) for a full list of options. Tip: To start XScreenSaver without the splash screen, use the -no-splash switch. You can view a list of the available X resources in /usr/share/X11/app-defaults/XScreenSaver.ĭo not forget to reload the resource file after changes. ! You can use a comma-separated list of fonts to set a fallback font. If you are using a non-default theme, replace default with the name of your chosen theme in lower case, or use question mark ( ?) to affect all themes: The example below demonstrates changing some colors and fonts. You can customize themes using X resources. You can select a theme using xscreensaver-settings or by changing the dialogTheme option ( dialogTheme: themename in ~/.xscreensaver or using X resources: xscreensaver-auth.dialogTheme: themename). Starting from version 6.0, XScreenSaver comes with several pre-installed themes. Since at least XScreenSaver 5.22, there is another way to edit XScreenSaver's user configuration, using X resources. Global options are defined in /usr/share/X11/app-defaults/XScreenSaver. xscreensaver-settings writes the chosen configuration to ~/.xscreensaver, discarding any manual modifications to the file. Most options are configured on a user-by-user basis by running xscreensaver-settings. 3.2 User switching from the lock screenįor an Arch Linux branded experience, install the xscreensaver-arch-logo AUR package.You can follow the same steps as in GNOME 3 desktop. To disable screen lock, simply change the setting in ~/.xscreensaver. You can also edit this file manually to adjust screen lock settings, without going through GUI. Once you change screensaver preferences via GUI like above, it will create ~/.xscreensaver, which is a screensaver preference file. In this settings, you can change screensaver activation time and screen lock delay, as well as enable/disable screen lock. ![]() To disable screen lock, simply change the following setting in ~/.kde/share/config/kscreensaverrc. Once the file is edited, the change will automatically take effect immediately. To adjust screen lock settings from the command line, you can edit ~/.kde/share/config/kscreensaverrc. After 300 seconds from that point on, screen lock will be activated, requiring password authentication. In this example, screensaver will be launched after 15 minutes of inactivity. Also, you can enable or disable screen locking. Here, you can change screen inactivity period and screen lock delay. Go to System Settings -> Display and Monitor. To install dconf-editor on Fedora: $ sudo yum install dconf-editor To install dconf-editor on Debian, Ubuntu or Linux Mint: $ sudo apt-get install dconf-tools To disable screen lock: $ dconf write /org/gnome/desktop/screensaver/lock-enabled falseĪlternatively, you can use dconf-editor, a GUI-frontend for dconf command. To activate screensaver and lock the screen after 10 minutes: $ dconf write /org/gnome/desktop/session/idle-delay 600 If you want to control screen lock from the command line, here is how to do it. In this setting, you can set screen inactivity period and screen lock delay. Go to System Settings -> Brightness and Lock. In this tutorial, I am going to show how to configure screen lock settings in various Linux desktop environments. ![]() ![]() Also, in case you want prevent your screen from going off and locked down for an extended period of time (e.g., when watching a movie), you probably want to disable screen lock feature. You may want to adjust these settings based on your typical work environment. The default screensaver is typically configurable, and you can change settings like inactivity period or screen lock delay. How to adjust screen lock settings on Linux desktopĮvery major Linux desktop nowadays comes with a screensaver program by default (e.g., xscreensaver), which then can be used to lock the screen for security purposes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |